[horde] Ingo blacklist filtering

[Simon Wilson]

I have a set of addresses in my blacklist filter rules and went  
through and tidied them up yesterday to try and sort them out a  
little... some of them were set to just the domain, e.g.  
"@spammer.domain", so I cleared out a
few that were specific senders and pushed them to be domain level,  
assuming that would be fine. I must have set them to that at some  
point over the last few years.

This morning I had an email come through from an address that I  
thought should be blocked, so I checked the blacklist - that looked  
fine, the email address matched a domain level blacklist entry. Then I  
noticed that the active script starts with this:

12: # Blacklisted Addresses
13: if address :all :comparator "i;ascii-casemap" :is  
["From","Sender", "Resent-From"] ["@....

I notice that the test is an "is" not "contains" - so it looks like  
domain level tests will fail as they won't match the "is".

Is there any way to make Ingo use "contains" - perhaps specifically  
for domain level entries as opposed to sender level?

Simon.

--
Simon Wilson
M: 0400 12 11 16
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: application/pgp-signature
Size: 189 bytes
Desc: PGP Digital Signature
URL: <http://lists.horde.org/archives/horde/attachments/20121004/2d7dd295/attachment.bin>