[horde] Ingo blacklist filtering

Simon Wilson simon at simonandkate.net
Wed Oct 3 23:45:59 UTC 2012


> I have a set of addresses in my blacklist filter rules and went  
> through and tidied them up yesterday to try and sort them out a  
> little... some of them were set to just the domain, e.g.  
> "@spammer.domain", so I cleared out a
> few that were specific senders and pushed them to be domain level,  
> assuming that would be fine. I must have set them to that at some  
> point over the last few years.
>
> This morning I had an email come through from an address that I  
> thought should be blocked, so I checked the blacklist - that looked  
> fine, the email address matched a domain level blacklist entry. Then  
> I noticed that the active script starts with this:
>
> 12: # Blacklisted Addresses
> 13: if address :all :comparator "i;ascii-casemap" :is  
> ["From","Sender", "Resent-From"] ["@....
>
> I notice that the test is an "is" not "contains" - so it looks like  
> domain level tests will fail as they won't match the "is".
>
> Is there any way to make Ingo use "contains" - perhaps specifically  
> for domain level entries as opposed to sender level?
>
> Simon.
>

I should say versions:

Horde 4.0.15
Ingo 2.0.9

Simon.
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: application/pgp-signature
Size: 189 bytes
Desc: PGP Digital Signature
URL: <http://lists.horde.org/archives/horde/attachments/20121004/ebe2995c/attachment.bin>


More information about the horde mailing list