[horde] Installing the RC

[Michael Rubinsky]

Quoting Simon Brereton <simon.brereton at dada.net>:

>> From: horde-bounces at lists.horde.org [mailto:horde-
>> bounces at lists.horde.org] On Behalf Of Simon Brereton
>> > > Then I reinstalled PEAR.  But when I ran pear upgrade it upgraded
>> a
>> > > few and complained about a lot of horde errors like:
>> > >
>> > > Validation Error: File
>> > > "js/syntaxhighlighter/scripts/shAutoloader.js" in directory "<dir
>> > > name="/">" has invalid role "horde", should be one of cfg, data,
>> > doc,
>> > > php, script, test, www Validation Error: This package contains
>> role
>> > > "horde" and requires package "horde/Role" to be used
>> >
>> > The error message is pretty clear. Install and run horde_role
>> *FIRST*,
>> > like explained in the installation instructions.
>>
>> Jan - as you can see from below though, this was a fresh install of
>> PEAR and and I hadn't even run the discover-channel command yet.
>> Doing pear install horde/horde-role at this stage didn't help either.
> <SNIP>
>> I'll attempt to completely remove pear again - and do the channel-
>> discover and the install horde-role first...
>
>
> Jan - I purged PEAR and rebooted
>
> The I ran  these commands with the attached out-put.
>
> root at jonty:~# pear channel-discover pear.horde.org
> Adding Channel "pear.horde.org" succeeded
> Discovery of channel "pear.horde.org" succeeded
>
> root at jonty:~# pear install horde/horde_role-beta
> downloading Horde_Role-1.0.0RC2.tgz ...
> Starting to download Horde_Role-1.0.0RC2.tgz (2,281 bytes)
> ....done: 2,281 bytes
> install ok: channel://pear.horde.org/Horde_Role-1.0.0RC2
> horde/Horde_Role has post-install scripts:
> /usr/share/php/PEAR/Installer/Role/Horde/Role.php
> Horde_Role: Use "pear run-scripts horde/Horde_Role" to finish setup.
> DO NOT RUN SCRIPTS FROM UNTRUSTED SOURCES
>
> root at jonty:~# pear run-scripts horde/horde_role
> Including external post-installation script  
> "/usr/share/php/PEAR/Installer/Role/Horde/Role.php" - any errors are  
> in this script
> Inclusion succeeded
> running post-install script "Horde_Role_postinstall->init()"
> init succeeded
> Filesystem location for the base Horde application : /usr/share/horde4
> Configuration successfully saved to PEAR config.
> Install scripts complete
>
> root at jonty:~# pear list-files horde/horde
> `horde/horde' not installed

Well, unless I missed it above, or you missed pasting it into the  
email, you didn't actually install horde. All you installed was the  
Horde/Role package. Please read the INSTALL documents again :)


--mike

The Horde Project (www.horde.org)
mrubinsk at horde.org