[ingo] ingo is modifying wrong .sieve file

[Thomas Preissler]

Mariusz,

thanks for that. I just checked and it is set to "Let a Horde  
application handle authentication", and that is "Imp".

So I checked the Imap config, and dont see anything obvious. I  
configured the whole thing intially to authenticate against my IMAP  
server, Dovecot.


Quoting Mariusz Czyz <mczyz at artic.edu>:

> Thomas,
>
> My wild guess is that Horde is setup to authenticate as a certain user,
> which could be you in this case.
>
> You can verify this by logging in with an administrative privileges and
> going to: Administration -> Setup -> Horde -> Authentication(tab), once
> there check what the $conf[auth][driver] is set to.
>
> Good luck,
> Mariusz
>
>
> On 01/12/2010 05:51 PM, Thomas Preissler wrote:
>> Hello,
>>
>> I have the following setup: The Horde authentication is done by IMAP,
>> ie. Dovecot, which works fine. I recently had to setup a vacation
>> message for an IMAP user who is not using Horde. Ok, no problem, it is
>> IMAP authentication, so that shouldnt be a problem.
>> So I logged in as that user to setup a vacation message. I got various
>> confirmations that it was alright, so I tested it. Long story short, I
>> found out, that the configuration for Sieve is written to _my own_
>> IMAP user (this was the first user who was used on Horde).
>>
>> I set the sieve file in Dovecot by passing a
>> userdb_sieve=[PATH]/Maildir/.dovecot.sieve
>> in the userlist.
>>
>> I enabled all sorts of debugging in Dovecot and can confirm that the
>> correct .dovecot.sieve file is used when email is delivered.
>>
>> Shortly, the issue is, that ingo is writing the rules to the wrong
>> file (it is actually always using the same file.) What can I do? I
>> just did a MySQL dump of the Horde database right now and looked for
>> sieve - nothing found. I was assuming the path/location is somewhere
>> in there.
>>
>> Any ideas?
>>
>>
>> Cheers
>> Thomas
>>
>>
>> Versions used
>> Horde Groupware Webmail Edition  1.2.5
>> Filters (ingo)  H3 (1.2.3)
>> Debian Lenny, up2date
>>
>
>